SunBriteTV SB-3260HD-SL manual Connecting to a Satellite or Cable SET-TOP BOX, Connecting with

TV Installation – Rear Panel Connection Diagrams

CONNECTING TO A SATELLITE OR CABLE SET-TOP BOX	Connecting with
	Component (Better)
Connecting with HDMI (Best)

1.Make sure the power of the TV and your set-top box is turned off.

1.Make sure the power of TV and your set-top box is turned off.

2. Connect a HDMI cable to the HDMI output of your set-top 2.	Obtain a Component Cable. Connect the green color
box and the other end to the HDMI port off the back of	connector to both your set-top box and Component 1’s green
your TV.	connector port off the back of your TV.

3.Turn on the TV and your set-top box.

4.Use the remote control’s source button or the source button on the right side of the TV to switch to HDMI 1.

Please Note :

1.Refer to the set-top box’s manual, to make sure the set- top box is configured to output correctly to the TV.

2.If HDMI 1 is already occupied, use HDMI 1 as your connection port and switch source to HDMI 2.

3.This model supports SONY’s universal remote code. If SunBriteTV is not listed, please look up SONY’s codes in your universal remote’s hand book.

4.This TV will turn off automatically if there’s no signal present for more than 15 minutes.

3.Connect the blue color connector to both your set-top box and Component 1’s blue connector port off the back of your TV.

4.Connect the red color connector to both your set-top box and Component 1’s red connector port off the back of your TV.

5.Obtain a RCA Audio Cable. Connect the white color connector to both your set-top box and Component 1’s white connector port off the back of your TV to the right side of your green, blue, red component connection.

6.Connect the red color connector to both your set-top box and Component 1’s red connector port off the back of your TV to the right side of your green, blue, red component connection.

7.Turn on the TV and your set-top box.

8.Use the remote control’s source button or the source button on the TV to switch to YPbPr1.

Please Note :

1.If Component 1 is already occupied, please use Component 2 is your connection port and switch to source YPbPr2.

2.Please refer to the set-top box’s manual to make sure the set- top box is configured to output correctly to the TV.

3.This model supports SONY’s universal remote code. If SunBriteTV is not listed, please look up SONY’s codes in your universal remote’s hand book.

4.This TV will turn off automatically if there’s no signal present for more than 15 minutes.

Page 14