TV Installation – Rear Panel Internal Connect Source
WARNING: Do not connect the power source before making connections.
Internal Connect Source
The Internal Connect Source allows you to easily connect to the Audio, Video,
1.Unscrew the two gray Thumb Screws (Figure1), and pull the cover towards you.
2.Route the cables to the proper inputs, and place the cable cords over the Rubber Sealing Gasket (Figure 2).
Note: There is an indentation on the Rubber Sealing Gasket on the bottom portion of the right and left sides.) Make sure cable cords are not placed on the indentation.
3.Close the cover.
4.Press firmly on the cover, and screw the Thumb Screws tightly (Figure3).
Figure 1 | Figure 2 |
Rubber Sealing Gasket
Thumb Screws
Cables are not to be placed
over the indentations
Figure 3
Thumb Screw
TV Installation - Connecting the Power Cord
Do not connect power cord until all cable connections have been made.
Connect the power cord to a GFCI protected AC outlet with an
WARNING:
TV AND GFCI RECEPTACLE MUST BE INSTALLED AT LEAST 5 FEET AWAY FROM STANDING WATER , SUCH AS (BUT NOT LIMITED TO) A POOL OR SPA.
Page 8
