A s s e m b l y o f 3 - P o s t S y s t e m
9
b.Find the end stopper from inside the top of the rail. The top por- tion is the section without the small trolley in it (Figure 20).
c.Using the Allen key provided, loosen the stopper in the upper portion of the rail and slide it out of the rail (Figure 21).
20.Place the end of the rail with the hooks onto the pivot post (Figure 22).
NOTE– Tilt the rail upward (45°) to latch the rail onto the post.
21.Extend the rail and thread the wheels of the trolley through the upper portion of the rail (Figure 23).
22.Continue to extend the rail through the metal
23.Add the stopper to the top portion of the rail.
a.Place the stopper in the upper portion of the rail with the rub- ber "bumper" leading (Figure 24). Slide stopper so it is approximately 1" (25 mm) from the end of the rail.
b.Using the Allen key, tighten the stopper in place.
c.Slowly move the rail from post to post to make sure it moves freely. If it does not move freely, the rail needs to extend further out.
CAUTION– Make sure the stopper is snug. DO NOT
d.Snap the flat blue cap onto the end of the rail (Figure 19).
24.Place one round blue end cap on the top of each post (Figure 25).
NOTE– Put the level and the Allen Key in a safe place as you may need them in the future.
25.Slide the blue plastic strips into the sides of the posts by pinching the strip on each side to press it into the grooves. Start at the bottom of the post (Figure 26).
26.See Figure 27 for photo of assembled
Figure 20
Figure 22
Figure 24
Figure 26
Figure 21
Figure 23
Figure 25
