|
| A | s | s | e | m | b | l y | o f | 3 - | P | o | s | t |
| S | y | s | t | e | m |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5.Take the pivot post out of the box and the post top for pivot post. Insert the post top into the post until it snaps into place (Figure 9).
6.Take top plate and
7.Place the post onto the foot plate and press down to tighten. Pay attention to the shape of the post and foot plate before pressing down onto the foot plate.
8.Place the top plate into the top of the post, pressing firmly and evenly downward until the top plate "clicks" into place (Figure 11).
9.Extend the post quickly towards the ceiling by pulling the top portion and holding the bottom portion.
The post should be within 3" (76
mm)of touching the ceiling. If the top of the post is more than 3" (76
mm)from the ceiling:
a.Raise the top portion of the post slightly (Figure 12).
b.Press in metal pin on both sides of the post (Figure 13).
CAUTION– Metal pins cannot be pressed in when there is downward pressure on them. Pressure must be released to press in pin.
c.Pull top portion of post up towards the ceiling.
d.Repeat until the top of the post is less than 3" (76 mm) from the ceiling.
10.Lift the blue locking handle out of the lower portion of the post. Using the blue piece as a handle, twist the post as follows (Figure 14):
a.Turn the top portion counter- clockwise.
b.Hold the bottom portion firmly.
11.Before the Easytrack post tightens against the ceiling, check the clip- on level to make sure the bubble is in the center of the circle. Tilt the post until the bubble reaches the center of the circle (Figure 15).
Make sure
Figure 9 |
|
| Figure 10 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
“Click”
Figure 11 |
| Figure 12 |
|
|
|
|
|
|
Figure 13 | Figure 14 |
Bubble
Figure 15