I X . S E T - U P , A D J U S T M E N T & U S E
2.Height-Adjustment
a)Release the upper securing lever (A).
b)Set at desired height
c)Return securing lever to locked position.
d)Move armrest up or down to allow armrest to snap into place
G. HEIGHT-ADJUSTABLE ARMRESTS (OPTIONAL)
1.Installation
a)Slide the outer armpost into the receiver mounted to the wheelchair frame.
b)The armrest will automatically lock into place.
2.Removing Armrest
a)Rotate release lever to first stop and remove the armrest.
3.Replacing Armrest
a)Slide armrest back into receiver.
b)Return release lever to locked position against armpost
4.
a)Rotate release lever to second stop.
b)Slide armrest pad up or down to desired height.
c)Return lever to locked position against armpost.
d)Push arm pad until upper armpost locks firmly into place.
5.Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a)Loosen the four bolts (9) on the sides of the receiver.
b)With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c)Tighten the four bolts.
6.Adjusting Inner Armpost Fit
a)Two set screws (7) are installed in the outer armpost (one on each side).
b)Turn the set screws in or out until the desired fit is achieved.
A
| 1 | 4 |
| |
2 | 6 | 3 | 5 | |
| ||||
7 | 8 | |||
| ||||
|
| |||
| 9 |
|
|
Height-AdjustableArmrest Key
1. Inner Arm Post
2. Receiver
3. Release Lever, Locked Position
4. Armrest Pad
5. Transfer Bar
6. Side Panel
7. Tension Adjustment Set Screws (Not shown)
8. Outer Arm Post
9. Receiver Adjustment Bolts
31 | 930317 Rev. C |
|
|
