Sunwave Tech SRC-1600 manual Manually setting preset codes

Using preset codes

Manually setting preset codes

1.Find your device in the supplied list of preset codes.

2.Press and hold to enter setup.

3.Press .

4.Find the digit code number from the pre-programmed code list.

5.Use the number buttons to enter the four digit code. (Refer to the pre-programmed code list table.)After you enter the last digit, a double beep sounds, confirming the code

has been input. If the number isn’t in the code data base, the SRC-1600 will beep three times continuously. Please try another number.

6.Check you have entered the correct code by pressing Volume +/–, Channel +/– or .

7.If the code is correct, press to confirm and exit. If the code is not correct, repeat step 4. See Checking the code number on page 14

13