SUPERSERVER 5015M-UR/5015M-U/5015M-NTR/5015M-NT User's Manual

Configuring the Adaptec SATA RAID

1. Press the <Del> key during system bootup to enter the BIOS Setup Utility.

Note: If this is the fi rst time you power on the system, we recommend that you load the Optimized Default Settings. If you have already done so, please skip to Step 3.

2.Use the arrow keys to select the "Exit" Settings. Once in the "Exit" settings, Scroll down to select "Load Optimized Default Settings" and press the <Enter> key. Select "OK" to confi rm the selection. Press <Enter> to load the BIOS default setting.

3.Use the arrow keys to select the "Main" section in BIOS.

4.Scroll down to "SATA Control Mode" and press <Enter> to select "Enhanced"

5.Scroll down to "SATA RAID Enabled" and press <Enter>. Then, select "En- abled."

6.Scroll down to "ICH RAID Codebase" and select "Adaptec". Then press <Enter>. (For Adaptec ICH RAID confi gurations: Change the setting from Intel to Adaptec.)

7.Scroll down to "Exit". Select "Exit Saving Changes" from the "Exit" menu. Press the <Enter> key to save the changes and exit the BIOS.

8.Once you've exited the BIOS Utility, the system will reboot.

9.During the system bootup, press the <Ctrl> and <A> keys simultaneously to run the Intel RAID Confi guration Utility when prompted by the following message: Press <Ctrl> <A> for Adaptec RAID Confi guration Utility.

D-2

Page 112
Image 112
SUPER MICRO Computer 5015M-UR, 5015M-NTR user manual Configuring the Adaptec Sata RAID