9-13
Chapter 9: Using the CFGGEN IR Configuration Utility
DISABLEIR Command (EFI Version Only)
The DISABLEIR command, which is currently supported only in the EFI version of
CFGGEN, disables Integrated RAID functionality on the supported SAS controller chips.
This is done by setting the MPI_IOUNITPAGE1_DISABLE_IR bit in the IO Unit 1 MPT
Configuration Page.
If there are any existing IM, IME, or IS volumes when this command is run, the user is
notified via an output message, no action is taken, and CFGGEN returns FAILURE. If
Integrated RAID is already disabled when this command is run, CFGGEN returns
SUCCESS.
Command Line –
cfggen <controller #> disableir
Parameters –
<controller #> – Number of the SAS controller targeted by this command.
Program Return Value –
0x00 SUCCESS: command completed successfully.
0x01 FAILURE: bad command line arguments or operational failure.
ENABLEIR Command (EFI Version Only)
The ENABLEIR command, which is currently supported only in the EFI version of
CFGGEN, enables Integrated RAID functionality on the supported SAS controller chips.
This is done by clearing the MPI_IOUNITPAGE1_DISABLE_IR bit in the IO Unit 1 MPT
Configuration Page.
If there are any existing IM, IME, or IS volumes when this command is run, the user is
notified via an output message, no action is taken, and CFGGEN returns SUCCESS. If
Integrated RAID is already enabled when this command is run, CFGGEN returns
SUCCESS.
Command Line –
cfggen <controller #> enableir
Parameters –
<controller #> – Number of the SAS controller targeted by this command.
Program Return Value –
0x00 SUCCESS: command completed successfully.
0x01 FAILURE: bad command line arguments or operational failure.