AOC-USAS-L8i Add-on Card User’s Manual
4-12
If you press Y, the program skips the bad block and continues. If you press N, the
program aborts the consistency check. The same message appears if the program finds
a hard media error on the target drive.
If you press ESC while a Check Consistency is running, the following options are
displayed:
•Stop: (Available only if AutoResume is enabled on the adapter by selecting:
MANAGEMENT MENU? J OBJECTS? J ADAPTER? J AUTORESUME.) The Check
Consistency is stopped, and the CU stores the percentage of the task already
completed. If AUTORESUME is enabled, the Check Consistency resumes where it left
off when you restart it, instead of starting over from zero percent.
•Continue: The Check Consistency continues normally.
•Abort: The Check Consistency is completely aborted. If you restart it, it begins at
zero percent.
4-7 Viewing and Changing Device Properties
The MegaRAID BIOS CU allows you to view properties for adapters, virtual drives, and
physical drives. You can also change some properties for adapters and virtual drives.

Viewing and Changing Adapter Properties

To view or change adapter properties, follow these steps:
1. On the MANAGEMENT menu, select OBJECTS J ADAPTER.
2. Select an adapter from the list. The following list of adapter properties appears:
Table4-1. List of Adapter Properties
Property Options Default
Rebuild Rate 0 to 100 (% of system resources) 30
Clk Const Rate 0 to 100 (% of system resources) 30
FGI Rate (Foregraound
Initialization rate) 0 to 100 (% of system resources) 30
BGI Rate (Background
Initialization rate) 0 to 100 (% of system resources) 30
Disk WC (Disk Write Cache) Off, On Off (Write Through enabled)
Read Ahead On, Off On
BIOS State Enable, Disable Enable
Stop on Error No, Yes No
Fast Init Enable, Disable Enable
Auto Rebuild On, Off On