2-10
SUPER P3TDDR User’s Manual
Wake-On-LAN (WOL1)
The Wake-On-LAN header is des-
ignated as WOL1. This function
allows your computer to receive
and be "woken up" by an incoming
call when in the suspend state.
See the table on the right for pin
definitions. You must enable the
LAN Wake-Up setting in BIOS to
use this function. (You must also
have a LAN card with a Wake-on-
LAN connector and cable to use
this feature.)
Wake-On-Ring (WOM1)
The Wake-On-Ring header is lo-
cated at WOM1. See the table on
the right for pin definitions. You
must enable the Ring Wake-Up set-
ting in BIOS to use this function.
(This feature requires a modem
connected to the computer that
has a Wake-on-Ring connector
and cable.)
Pin
Number
1
2
3
Definition
+5V Standby
Ground
Wake-up
Wake-On-LAN
Pin Definitions (WO L 1 )
Pin
Number
1
2
3
Definition
+5V Standby
Ground
Wake-up
Wake-On-Modem
Pin Definitions (WO M 1 )
Note: NC indicates no connnection.
Serial Ports
One COM serial port connector is
provided on your board. See the
table on the right for pin defini-
tions. A 10-pin serial ribbon cable
is required to connect a device to
the COM2 header, which is lo-
cated near the PCI1 slot.
Pin Number Definition
1 DCD
2 Serial In
3 Seri a l O ut
4 DTR
5 Ground
Pin Number Definition
6 DSR
7 RTS
8 CTS
9 RI
10 NC
Serial Port
Pin Definitions (CO M 1 /2)