SBI-7226T-T2 Blade Module User’s Manual
1-3 Blade Module Features
Table 1-1lists the main features of the SBI-7226T-T2 blade module. See the proceeding section for components typically included in a blade system and other optional components. Specific details on the SBI-7226T-T2 blade module is found in Chapter 4: "Blade Module Features" on page 4-1.
Table 1-1. SBI-7226T-T2 Blade Specification Features
Mainboard
Processors
FSB Speed
Chipset
Graphics Controller
BIOS
Memory Capacity
SATA Controller
Hard Drive Bays
B8DTT (proprietary form factor)
Chassis Dimensions (HxWxD): 11.32” x 1.67” x 20.5”
Supports two 1366-pin LGA Socket processors in each node for up to four Intel® 64-bit quad-core Xeon® series processors. Please refer to our web site for a complete listing of supported processors.
QPI speed Up to 6.4 GT/s
Intel 5500/IOH-24D Tylersburg + ICH10R
Onboard Matrox G200eW Graphics chip with 16MB of SDRAM
32 Mb AMI® SPI Flash EPROM BIOS
Eight 240-pin DIMM sockets per node supporting up to 64 GB of ECC Registered DDR3-1333/1066/800 SDRAM DIMMs or 16 GB of ECC Unbuffered DDR3-1333/1066/800 SDRAM DIMMs in two 3-DIMM and two 1-DIMM memory banks for each node.
SATA Controller ICH10R on-chip controller for four Serial ATA drives, two for each node
Four (4) hot-swap drive bays for 2.5" SATA disk drives
Processors
The SBI-7226T-T2 blade module supports up to two 1366-pin Intel Xeon 5500 series processors in each node for a total of four.
Refer to the Supermicro web site for a complete listing of supported processors (http:// www.supermicro.com/products/superblade). Please note that you will need to check the detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBI-7226T-T2 blade module are found in Chapter 3: "Setup and Installation" on page 3-1.
Memory
The SBI-7226T-T2 blade module has eight 240-pin DIMM sockets in each node that can support up to 16 GB of ECC Unbuffered DDR3-1333/1066/800 SDRAM or 64 GB of ECC Registered DDR3-1333/1066/800 SDRAM DIMMs. Both interleaved and non-interleaved memory are supported, so you may populate any number of DIMM slots.
