SBI-7426T-S3 Blade Module User’s Manual

3-8
DIMM Installation
Installing DIMM Memory Modules
1. Power down the blade module (see "Powering Down a Blade Unit" on page3- 1).
2. Remove the blade from the enclosure and the cover from the blade (see
"Removing/Replacing the Blade Cover" on page3-2).
3. Remove the air shroud that covers the DIMM slots.
4. Insert each DIMM vertically into its slot, starting with slots 1A and 2A. Pay attention
to the notch along the bottom of the module to prevent inserting the DIMM
incorrectly (see Figure3-6).
Figure3-6. Installing a DIMM into a Memory Slot
5. Gently press down on the DIMM until it snaps into place in the slot. Repeat for all
modules (see Table 3-1 for installing DIMMs into the slots in the correct order).
6. Replace the air shroud and the blade cover and install the blade module back into
the enclosure.
7. Power up the blade unit (see "Powering Up a Blade Unit" on page3-1).
WARNING: Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
To Install: Insert module vertically
and press down until it snaps into
place. Pay attention to the bottom
notch.
To Remove: Use your thumbs to
gently push each release tab
outward to free the DIMM from the
slot.