SBI-7426T-S3 Blade Module User’s Manual
| Table |
|
|
Menu Option | Description |
RAID ID Support | This setting allows you to select either the Intel or ADAPTEC RAID Configuration |
Utility to be used for configuring your RAID setup. This setting is only available | |
| when RAID is selected for SATA#1 Configuration. |
| This setting allows you to enable the Hot Plug feature when using RAID for your |
Hot Plug | SATA devices when RAID is selected for your SATA#1 Configuration. Options |
| include ENABLED or Disabled. |
|
|
SATA#2 | Selecting Enhanced sets SATA#2 to native SATA mode. The options are |
Configuration | DISABLED and Enhanced. |
Hard Disk Write | This setting Enables/Disables device write protection and is effective only if the |
Protect | device is accessed through BIOS. The default is Enabled. |
IDE Detect Tie Out | This setting allows you to select the time out value for detecting ATA?ATAPI |
(Sec) | devices. Press + or - on your keyboard to change this value. The default is 35. |
ATA(PI) 80Pin Cable | This setting allows you to select the mechanism for detecting 80P in ATA(PI) |
Detection | cable. The default is Host & Device. |
Table 6-5. PCIPnP Configuration Sub-menu
Menu Option
Clear NVRAM
Plug & Play O/S
PCI Latency Timer
Allocate IRQ to PCI VGA
Palette Snooping
PCI IDE BusMaster
Offboard PCI/ISA IDE Card
IRQ3 ~ IRQ11
Description
This setting allows you to clear NVRAM during a system boot. The options are No and YES.
Selecting YES allows the OS to configure Plug & Play devices. Select No to allow the AMI BIOS to configure all devices in your system.
NOTE: This is not required for system boot (select No) if your system has an OS that supports Plug & Play.
This sets the latency timer of each PCI device installed on a PCI bus. For example, select 64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128, 160, 192, 224 an 248.
Select Yes to assign IRQ to the PCI VGA card if the card requests IRQ. Selecting NO does not assign IRQ to the PCI VGA card even if the card requests an IRQ.
When ENABLED, this informs PCI devices that an ISA graphics device is installed in the system so the card will function correctly. The default is Disabled.
When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE devices. The options are DISABLED and Enabled.
Some PCI IDE cards may require this setting to be set to the PCI slot number that is holding the card. The default Auto setting works for most PCI IDE cards.
When each of these settings is set to Available, the specified IRQ is available to be used by PCI/PnP devices. If set to RESERVED, the IRQ is reserved for use by lagacy ISA devices.
