SC512 Chassis Manual
Routing Cable (1A) from Hard Drive (1B)
1.Plug cable (1A) into the SATA port of hard drive (1B).
2.Lift up the fan and run cable (1A) straight out from the port and under the fan.
3.Route cable (1A) over the hard drive and through the left middle bracket.
4.Plug cable (1A) into upper SATA port (1C) on the motherboard.
Routing Cable (2A) from Hard Drive (2B)
1.Plug cable (2A) into the SATA port of hard drive (2B).
2.Run cable (2A) upwards at a right angle, up and over the top of hard drive (2B).
3.Route cable (2A) through the left middle bracket.
4.Plug cable (2A) into lower SATA port (2C) on the motherboard.
Routing Split Cable (3A)(4A) from Hard Drives (1B)(2B) to the Power Supply
1.Plug the end of the split cable (3A) into hard drive (2B).
2.Route the end of the split cable (3A) straight up at a right angle, beside the fan, and over the top of cable (1A).
3.Plug the end of the split cable (3A) into connector (3B).
4.Plug the other end of the split cable (4A) into hard drive (1B).
5.Route the end of the split cable (4A) straight up at a right angle, along the top of the fan.
6.Route cable (5A) through the right middle bracket and plug it into connector (3B).
