Maintenance
CAUTION: DO NOT OPERATE THE APPLIANCE WITH A BROKEN, DAMAGED OR MISSING CATALYTIC COMPONENT.
The appliance should be inspected before use and at least annually by a professional service person. Replace the catalytic component if CO levels measured at the appliance vent outlet exceed 1/1000 of 1% after (10 Min) of burn- ing. Replacement of the catalytic component should only be completed by a qualified ser- vice person at least every 20 years.
Ensure the air shutter openings are not ob- structed (see Figure 22 ).
Cleaning and Servicing
WARNING: TURN OFF THE APPLIANCE AND ALLOW TO COOL BEFORE CLEAN- ING.
WARNING: ALWAYS TURN OFF THE GAS SUPPLY TO THE PILOT BEFORE CLEAN- ING. BEFORE
Clean the glass only when necessary. Wipe surface with a clean, dampened, soft cloth. Follow with a dry, soft towel as desired. Take care not to scratch the glass surface.
WARNING: DO NOT USE ABRASIVE CLEANERS. NEVER CLEAN THE GLASS WHEN IT IS HOT.
If, after a period of use, the flames start to exhibit unusual shapes and behavior, or the burners fail to ignite smoothly, then the burner holes may require some cleaning. If this oc- curs, it is preferable to contact your nearest dealer to service the appliance.
Alternatively, at least annually, the glass enclo- sure panel should be removed and the inside of the firebox and the control compartments cleaned using a vacuum cleaner to remove dust. Remove the top and bottom logs, gently handling by holding each log at each end and set on a piece of paper or cloth to avoid getting any debris on carpet or floor. Use the vacuum cleaner to remove the embers from the base and walls of the firebox and from around the burners. More frequent cleaning may be re- quired due to excessive lint from carpeting material, etc. It is important that control com- partments, burners and circulating air pas- sageways of the heater be kept clean. Replace the logs as detailed in Step 9 Log Assembly. Place Rockwool on screen of front burner.
CAUTION: REPLACE THE GLASS ENCLOSURE PANEL BEFORE USING THE APPLIANCE (RE- FER TO STEP 11).
IMPORTANT SAFEGUARDS
Even though your CF appliance gives a very realistic appearance of a
To avoid personal injury, do not touch hot surfaces when the appliance is operating. Close supervision of children is necessary when the appliance is in use.
SPECIAL WARNINGS
Do not open the louvered control compartment access panel from the middle when unit is hot. Only the ends of the louvers are cool to the touch.
The glowing logs are manufactured from bonded ceramic fiber which is commonly used material in the heating industry worldwide.
Intentional misuse or deliberately fragmenting the material could be hazardous to health by inhaling.
These CF appliances are intended for use as a gas heater as described in these instructions and should not be used for any other purpose.
Repair and work involving replacing parts should only be carried out by a qualified ser- vice person.
Always shut off the gas supply and allow the appliance to cool before beginning any service work.
Always check for gas leaks after servicing.
If any major repair or service is required, the qualified service person must contact the SFC, INC. service department before proceeding.
REPLACEMENT PARTS
Exploded views of the appliances with num- bered parts and parts lists can be found on pages 18 and 19. All parts should be ordered through your SFC distributor or dealer. Parts will be shipped at prevailing prices at time of order. When ordering repair parts, always give the following information:
1.The model number of the appliance.
2.The serial number of the appliance.
3.The part number.
4.The description of the part.
5.The quantity required.
6.The installation date of the appliance.
If you encounter any problems or have any questions concerning the installation of this system, please contact your distributor. For the name of your nearest distributor contact:
SFC
1110 West Taft Avenue
Orange, CA 92865
13
