5.8.3. Transmitting data
After the pairing procedure, the Suunto D9 will receive cylinder pressure data from the transmitter. The pressure is displayed in either bars or psi, depending on the unit selected. Any time the Suunto D9 receives an appropriate signal it flashes the lightning figure in the display’s lower left corner. A pressure reading of over 360 bar/5220 psi will display as
If the Suunto D9 is unable to receive a valid signal for more than one minute it will start displaying “FAIL” intermittently with the latest valid pressure reading.
If the transmitter battery is running low, a low battery warning “LOB” will be transmitted and displayed intermittently with the pressure reading.
If the dive is started without the Suunto D9 and the transmitter having been properly paired, the dive computer will indicate that no cylinder data is available by displaying “OFF”.
Table 5.4. Pressure transmission related displays |
| |
Display | Indication | Figure |
Set Code. No code stored, Suunto D9 ready for pairing with | A | |
| transmitter. |
|
- - -
FAIL
Pressure reading over 360 bar/5220 psi
Indicates pressure reading has not been updated for more than one minute. Transmitter is out of range, in power saving mode or on another channel. Activate the transmitter by breathing off the regulator, and recode the wrist unit if necessary.
B
C
44
