SVAT ELECTRONICS
Now You Can See
2. INSTALLATION
CONNECTORS ON THE REAR PANEL
Please setup the connection by following the illustration shown below (detailed instructions on using the network function can be found in Section 9):
1)Plug the power cord into your DVR and plug it into an outlet. SVAT recommends plugging it into a surge protected power bar for your device's protection.
2)Plug the BNC Connectors into each video input you plan on using. For
example, if you are using 3 cameras with this system, then plug BNC convertors into inputs
3)Plug your camera(s) into the video input jacks using the 60ft extension wires.
4)Use an RCA wire to connect your television to the video output of the DVR. Make sure the RCA wire is plugged into the video input of your television. Note: This system does not support audio, so if you are using an audio/video RCA wire, there is no need to plug in the red or white inputs. On your television switch to the video/audio input channel
5)Your system is now installed and ready for use.
CV0204DVR | 5 |
