BOTTOM RAIL AND STRAP LAYOUT |
| 4 | ||||||
Follow the instructions below to properly layout the rail and strap assemblies. |
|
| ||||||
|
|
|
|
|
|
|
|
|
|
| QUANTITIES NEEDED: |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
POOL SIZE | 16 x 10 | 18 x 12 | 24 x 12 | 24 x 15 | 30 x 15 | 33 x 18 | 39 x 18 | 45 x 18 |
STRAP ASSEMBLIES | 3 | 3 | 5 | 4 | 6 | 6 | 8 | 10 |
|
|
|
|
|
|
|
|
|
SHORT RAILS | 4 | 4 | 8 | 6 | 10 | 10 | 14 | 18 |
|
|
|
|
|
|
|
|
|
LONG RAILS | 10 | 10 | 10 | 10 | 10 | 12 | 12 | 12 |
BOTTOM PLATES | 8 | 8 | 8 | 8 | 8 | 10 | 10 | 10 |
EXAMPLE OF BASIC LAYOUT | Ground Shield |
(Optional) |
Long
Bottom Rail
Bottom Plate
Patio Block |
| Strap Assembly |
| Short | |
|
| |
| Bottom Rail |
|
BOTTOM RAIL
BOTTOM PLATE |
|
PATIO BLOCK | 1/16” |
PRE WASHED SAND OR
SIFTED EARTH RECOMMENDED
REQUIREMENT CHART
POOL SIZE | TONS | YARDS |
|
|
|
16’ x 10’ | 2.0 Tons | 1.3 Cu. |
|
|
|
18’ x 12’ | 2.4 Tons | 1.6 Cu. |
24’ x 12’ | 3.3 Tons | 2.2 Cu. |
24’ x 15’ | 3.8 Tons | 2.5 Cu. |
|
|
|
30’ x 15’ | 4.8 Tons | 3.2 Cu. |
|
|
|
33’ x 18’ | 6.0 Tons | 4.0 Cu. |
39’ x 18’ | 7.2 Tons | 4.8 Cu. |
45’ x 18’ | 8.3 Tons | 5.5 Cu. |
|
|
|
GROUND SHIELD AND
WALL GUARD ARE OPTIONAL
Spread a ground shield or plastic sheeting over prepared ground (not included). Ground Shield and Wall Guard are available from your local pool supply dealer or polyethylene sheeting can be purchased from a local hard- ware supply. This will protect your pool liner and metal parts against chemical reactions from the ground soil.
|
|
|
|
Short | Long | ||
Bottom Rail | Bottom Rail | ||
|
| From Oval End of Pool | |
Mark out pool radius (1/2 pool width) using stakes "B" as a reference. Form the two end semicircles by sliding the long bottom rail groove up, into the bottom plates. Lay out the strap assemblies as shown removing the stakes as you go. The distance from strap to strap is 36". Install the short bottom rail in between each strap as shown.
Bring the required amount of sifted earth or
10
