SERVICE & ADJUSTMENTS
Engine to Deck Belt
Removal
9Apply parking brake
9Lower the deck to its lowest position
9Disconnect tension idler
9Remove belt from the mower deck and the electric clutch
Seat Adjustment
Replacement
9Install new belt by placing it around the electric clutch and route it through the idler and around the deck pulley.
Refer to routing diagram below.
9The belt will be loose at this time
9Tightly secure the belt tension back to its original position
9The Swisher ZT2350 is equipped with a 6” range sliding seat.
9Release the tension on the seat adjustment lever by pushing the yellow tip lever to the left. See features section in this manual
9Using your own weight, slide the seat to the desired position
9Release the lever
Travel Reduction Adjustment (Ref. Page 29)
9To improve the tracking of the Swisher ZT2350 the speed of one of the rear wheels needs to be decreased. If the ZT2350 pulls to the right the left wheel will need to decrease speed and if pulling to the left the right wheel will need to decrease speed.
9To decrease the speed in one of the rear wheels turn the bolt (item 16) counter clockwise. This will limit travel of the handle. Ensure after the bolt has been moved that the nuts holding the bolt in place are securely tightened.
24