Swisher ZT2350A manual Service & Adjustments, Parking Brakes

SERVICE & ADJUSTMENTS

Parking Brakes

9The Swisher ZT2350A is equipped with a Parking Brake system activated by pulling the brake knob (10) up.

9Adjustment for the system is located on the ends of the brake weldment rod (18).

9Raise the rear wheel off the ground.

9Disengage the hydro to be adjusted with the hydro release handle at the rear of the unit

9Adjust so that the brake is not on when the handles are in the operator position. The wheel should turn freely.

9The wheel should not turn when the brake is engaged.

9To tighten the brake, turn the adjustment nuts towards the end of the cable.

9Recheck adjustment with control handle

9Lower unit back to the ground

9Reengage the hydro at the rear of the unit

ITEM #	DESCRIPTION	PART #
1	Weldment; Rod Mount - ZTR Brake	13190
2	Plate; Clasp - ZTR Brake	13191
3	Weldment; Rod Pivot	13195
4	Weldment; ZTR Brake Linkage - Left	13202
5	Weldment; ZTR Brake Linkage - Right	13198
6	Spacer	B99S
7	5/16-18 x 3/4 FLANGE BOLT	NB596
8	5/16-18 SERR FLANGE NUT	NB170
9	Weldment; Push Rod, ZTR Brake	13207
10	SHIFT KNOB	B19
11	3/32 X 1 Cotter Pin	NB708
12	1/4-20 Flange Nut	NB524
13	5/16-18 Jam Nut	NB173
14	1/4-20 X 3/4 Flange (Self Cutting)	NB690
15	Two Speed Spring (AZ32 1998)	TZ2S
16	1/4 SAE Washer	NB274
17	1/4-20 Nylok Nut	NB180
18	Weldment; Rod 5/16-18 x 11 1/2; 2 1/2	E13208
19	Link - Clutch Chain	T2L

25