Sylvania LC320SL1 owner manual Initial Setup

These operations are accessible by remote control.

Some may also be accessible by controls on the main unit.

Initial Setup

This section will guide you through the unit’s initial setting which includes selecting a language for your on-screen menu and autoprogram, which automatically scans and memorizes viewable channels.

Before you begin:

Make sure the unit is connected to antenna or cable.

1 After making all the necessary connections, pressto turn on the unit.

•It may take a few moments to turn on the unit for the first time.

•[Initial Setup] menu appears automatically after the unit is turned on.

2 Use ▲/▼ to select the on-screen language from the choices (English / Español / Français) on the right side of the TV screen.

3 Use ▲/▼ to select [Antenna] for TV channels or [Cable] for CATV channels, then press OK

Initial Setup

Make sure the antenna is connected to ''ANT. IN'' jack.			Antenna
Select your signal source.			Cable
			Skip
Antenna	Or
Cable		ANT.IN
Select	OK	Back	Skip

•[Autoprogram] will begin.

Initial Setup

Please wait while the system is scanning for channels.

Auto programming may take more than 20 minutes to complete.

0%

Digital channels	0 ch
Analog channels	0 ch

Skip

English

4 Use ◄/► to select the desired location setting, then							INTRODUCTION
	press OK
	Initial Setup
		Select “Retail” or “Home” for your location.
			Select		OK		PREPARATION
			Retail		Home
	•	Select [Retail] store, the unit will be set up with
		predefined setting for retail displays. In this setting, the					WATCHING
		power consumption may possibly exceed the limited
		requirement of the ENERGY STAR® qualification.
	•	Select [Home], the unit is set to maximize the energy
		efficiency for home setting and it can be adjusted					TV
		through a choice of picture and sound quality according
		to your preference.
	•	When the initial setup is completed, the lowest
							OPTIONAL
		memorized channel with the confirmation message of
		the location setting will be displayed on the TV screen.
Note							SETTING
If you are not receiving a signal from your cable service, contact the Cable
provider.
If you press			or MENU during autoprogram, this setting will be canceled.
The initial autoprogram function can be executed for either [Antenna] or
[Cable] only once.When you change the connection (Antenna / Cable),							TROUBLESHOOTING
set [Autoprogram] again.
If there is no signal input from the antenna terminal and no operation for
several seconds after you turn on the unit, [Helpful Hints] appears. Follow
the instructions listed on the TV screen.
		Initial Setup
		No channel is registered.				Retry
						Later
		Try Autoprogram again?					INFORMATION
		Verify that you have a cable connected to the "ANT. IN" jack on the
		back of the TV, the channel installation process searches this
		connection. If you are using a cable or satellite box, please confirm the
		input which you have connected the box and press "SOURCE" key on
		the remote control to select the appropriate source input.
			Select	OK	Skip

You must set [Home] in step 4. Otherwise, the settings of picture and sound quality you adjusted will not be memorized after you turn off the unit.

After an initial setup is completed...

•If you want to scan the channels automatically again.

[Autoprogram] ➠ p.19

•You can add the desired cable and analog channels unmemorized by autoprogram.

[Add Channels] ➠ p.20

•If you want to change to another language.

[Language Selection] ➠ p.21

•If you want to change the location setting.

[Location] ➠ p.30

15

EN