Sylvania LC320SS1 owner manual Preparation, Antenna Connection, Receiver / satellite box

PREPARATION

No supplied cables are used with these connections:

Please purchase the necessary cables at your local store. High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility.

Before you connect:

Be sure your antenna or other device is connected properly before plugging in the AC power cord.

Antenna Connection

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

LC320SS1

VHF / UHF
analog
or	rear of this unit
DTV antenna
	RF coaxial cable
	or
cable TV signal
LC260SS1	RF coaxial cable

rear of this unit

Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area.[Initial Setup] ➠ p.15

Note

•If you have any question about the DTV’s antenna, visit www.antennaweb. org for further information.

•Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

•For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than a set top or inside antenna.

•To switch your reception source easily between antenna and cable, install an antenna selector.

•If you are not receiving a signal from your cable service, contact the Cable provider.

						English
Connection to Cable Receiver or								INTRODUCTION
Satellite Box
Use an HDMI or component video cables to connect the
HDMI or the Component Video Input jacks of the unit to
the HDMI or the component video output jacks of the cable
receiver / satellite box.
If you connect to the unit’s Component Video Input jacks,								PREPARATION
connect audio cables to the Audio L/R Input jacks right beside
the Component Video connector.
e.g.)
LC320SS1
satellite dish								WATCHING
	RF coaxial cable				cable receiver /
or		ANT IN			satellite box			TV
						STEREO
						PCM		OPTIONAL
cable TV signal	HDMI OUT		L	R	Y	Pb/Cb	Pr/Cr
including PPV
			AUDIO OUT		COMPONENT VIDEO OUT
		or						SETTING
					(green) (blue)		(red)
			component video cables
				(red/blue/green)				TROUBLESHOOTING
HDMI cable				and audio cables
or
								INFORMATION
or

side or rear of this unit

9

EN