Sylvania LC320SS1 Supplied Accessories, Symbols Used in this Manual, Attaching the Base

Supplied Accessories

Owner’s manual	Quick Start
(1EMN25841)	(	LC320SS1:LC260SS1: 1EMN258421EMN26283 )

Remote control

(NH200UD)(1EMN24700)

Batteries	Screw kit
(AAA, 1.5V x 2)	for attaching the base
	LC320SS1: 1ESA19881
AAA	( LC260SS1: 1ESA23705 )
AAA

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Note

If you lose the screws, please purchase M4 ×20 Phillips head screws at your local store.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

ATSC : Digital TV operation

NTSC : Analog / Cable TV operation

•If neither symbol appears, the operation is applicable to

both.

English

			INTRODUCTION
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction.
1 Spread a thick and soft
	cloth over a table as
			PREPARATION
	shown.
	Place the main unit face
	down onto it. Make sure
	not to damage the screen.
	At least 2 people are
	required for this step.
2 Insert 2 hooks under the
			WATCHING
	bottom of the main unit
	into base holes. (shown by ➁
	arrow ➀), then move the
	base in the direction as		TV
	shown by arrow ➁ until it
		➀
	stops and the 4 mounting
	holes are aligned. Make		OPTIONAL
	sure not to put the AC
	power cord between the
3	base and the unit.		SETTING
	into the 4 threaded holes
	Drive Phillips pan screws
	at the bottom of the base
	shown by arrow ➁ on step 2, then pull the base up toward the rear of the		TROUBLESHOOTING
	until they are tight.
To remove the base from this unit
	Unscrew the Phillips pan screws on step 3
	After the screws are removed, move the base in the opposite direction as
	unit. Be careful not to drop the base when you remove it.
Note			INFORMATION
	larger than this unit.
	When attaching the base, ensure that all screws are tightly fastened. If the
	base is not properly attached, it could cause the unit to fall, resulting in
	injuries as well as damage to the unit.
	Make sure to use a table which can support the weight of this unit and is
	Make sure the table is in a stable location.
	When attaching the base, ensure that FRONT ↑ written on the base is
	upward. If it's not upward, the 2 hooks don't fit in the base.

Fixing the Unit on Your Furniture

Screw this unit on your furniture tightly using wood screws

(not supplied) in the 2 holes at the back of the base as shown.

Recommended screw dimension : 5.1 x 20 mm

rear of this unit

Note

•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.

5

EN