Sylvania LC320SS1 owner manual Optional Setting, Autoprogram, Main Menu

English

OPTIONAL SETTING	Autoprogram
	If you switch wires (e.g. between antenna and CATV) or if you
	move the unit to a different area after the initial setting, or if
	you restore the DTV channels you deleted, it is recommended
Main Menu
	to use Autoprogram to perform a new channel search.
This section describes the overview of the main menu	Before you begin:

displayed when you press MENU. The main menu consists of			Make sure the unit is connected to antenna or cable.
the function setting items below.			1 Press MENU to display the main menu.
Press MENU.
			2 Use ▲/▼ to select [Setup], then press OK.
	Picture
	Sound		3 Use ▲/▼ to select [Autoprogram], then press OK.
	Setup
			4	Use ▲/▼ to select an appropriate option, then press OK.
	Features
	Language				Autoprogram
				Picture	Autoprogram will rescan all channels.		Back
				Sound	Auto programming may take more than 20 minutes to		Antenna
Picture	[Picture Adjustment]	➠ p.22			complete.		Cable
					Select your signal source.
Sound	[Sound Adjustment]	➠ p.22		Setup
Setup	[Autoprogram]	➠ p.19			Antenna
	• You can automatically scan the viewable channels.			Features
				Language	Cable	Or
	[Channel List]	➠ p.20
						ANT.IN

•The Channels that were autoprogrammed are in

this Channel list, use CH +/–to access them.		• When connected to VHF / UHF antenna,
[Add Channels]	➠ p.20	select [Antenna].
• You can add TV channels that were not found by		• When connected to CATV, select [Cable].
the autoprogram scan.		• [Autoprogram] will begin.

INTRODUCTION PREPARATION WATCHING TV OPTIONAL SETTING TROUBLESHOOTING

Features [Closed Caption] ➠ p.24

•You can change the display closed caption format which displays the dialogue of aTV program or other text information across theTV screen.

[Child Lock] ➠ p.27

•You can set viewing limitations.

[Fun-Link] ➠ p.29

•You can set Fun-Link options.

[Energy Saving Mode]	➠ p.30
[Location]	➠ p.30

•Switch setting from [Retail] to [Home] to allow the desired [Picture] and [Sound] mode to be kept in memory.

[Current Software Info]	➠ p.30
Language [Language Selection]	➠ p.21

•Change the Main Menu language.

Please wait while the system is scanning for channels.

Auto programming may take more than 20 minutes to complete.

75%

Digital channels	10 ch
Analog channels	6 ch

Exit

•When the scanning and memorizing are completed, the lowest memorized channel will be displayed.

Note

•After setting [Autoprogram], using CH +/− on the remote control skips unavailable programs automatically.

•If you are not receiving a signal from your cable service, contact the Cable provider.

•If you press or MENU during autoprogram, the setting will be canceled.

•Even if [Autoprogram] is completed, the channel setting will be lost if the AC power cord is unplugged before turning off the unit by pressing .

•The PIN code will be required once you set a PIN code in the [Child Lock].

➠ p.27

•If you want to change your PIN code, follow the instruction of [Change PIN]. ➠ p.28

INFORMATION

19

EN