Symphonic SF225B Preparation For Use, Antenna/Cable Connections, Using Audio/Video Input Jacks

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

For some of the most common types of connections, please refer to the followings. Use only one connection. For any further complex connections, please contact your local dealer. (You may need additional accessories which are not supplied).

1Disconnect the antenna or cable from your TV.

3Connect one end of the coaxial cable (supplied) to the ANT.OUT (Bottom jack) of your VCR.

2Connect the antenna or cable to the ANT.IN (Top jack) of your VCR.

4Connect the other end of the coaxial cable (supplied) to the UHF/VHF antenna jack of your TV.

Basic Connections

	ANT
	IN
AUDIO
OUT IN	OUT
VIDEO	CH3 CH4

Back of the VCR

Coaxial Cable

(Supplied)

[Cable Box or Satellite Box]

From

Cable or

Satellite

ORCompany

Indoor or Outdoor Antenna

OR

From

Cable Company

(No Cable Box)

ININ

L R

AUDIO VIDEO

VHF VHF

UHF UHF

OR

ANT in

TV A/V Terminal

TV Antenna Terminal

USING OPTIONAL AUDIO/VIDEO OUTPUT JACKS

If your TV has A/V input jacks, you may connect your VCR’s AUDIO/VIDEO OUTPUT jacks to the audio/video input jacks on back of your TV.

Direct audio/video connections usually result in a better picture and sound quality for tape playback. Please see your TV’s owner’s manual for A/V input connections.

USING AUDIO/VIDEO INPUT JACKS

You can use A/V input jacks on back panel.

●When you connect the External source to jacks on back panel, select "Line-in" position for recording by pressing the 0, 0 on the remote control or CHANNEL Up/Down button.

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

- 6 - EN

0J11