T S - 6 0 0 U S E R G U I D E
CONFIGURE THE OUTSIDE LINE ACCESS CODE
The outside line access code is dialed prior to any number over 6 digits stored in the directory, speed dial buttons, or the call log. A stored number with 6 or fewer digits is considered an internal number.
The outside line access code is not dialed for an internal call. A 3 second pause is inserted automatically between the outside line access code and the phone number.
Use Save to End
9
#= DLA Mode Enable Enter Access Code
Extensions with Direct Line Access
Direct Line Access allows you to access the outside phone lines directly, without having to enter a line access code. If your TalkSwitch extension is programmed for Direct Line Access, enter # as your line access code. This will ensure that features and dialing operate properly for your extension. Refer to your TalkSwitch programming guide for more information.
To enter outside line access code:
1. | Press the | M E N U | button followed by | 2 . |
2. | Enter your outside line access code or | # if your extension is configured for | ||
| Direct Line Access. |
|
| |
3. | Press the | S A V E | button to store the access code. | |
Selecting ring tone
You can select one of four ring tones for this telephone:
1. Press the M E N U button followed by 3 .
2.The phone rings with Ring Tone 1 for about 2 seconds.
Use Save to End
Use S/T Enter to Select 1 = Ring tone 1
2 = Ring tone 2
3 = Ring tone 3
4 = Ring tone 4
3. Press the | S A V E | button to select Ring Tone 1; or |
4. Press the S button or the T button to select another ring tone.
5. After the end of the desired ring tone, press the | S A V E | button to select it. |
Adjusting the display angle
You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD viewing angle, move the rear edge of the LCD module up or down.
6 | W W W.T A L K S W I T C H . C O M |
