Talkswitch TS-600 manual Connecting power directly from the AC adapter, Wall Mounting

T S - 6 0 0 U S E R G U I D E

Connecting power directly from the AC adapter

Alternatively, you can power this phone by directly connecting the AC power adapter to the phone.

1.Remove the rubber cap covering the DC12V plug behind the phone. It is located beside the TEL LINE jack.

2.Connect the AC adapter plug to the DC 12V jack of the telephone.

3.After installation, lift the telephone’s handset and listen for the dial tone. If there is no dial tone, check to make sure all cords are firmly plugged into their jacks.

WALL MOUNTING

1.Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at the narrow end of the wall-mount bracket into the holes at the rear of the phone bottom. Press and latch the tabs at the thicker end of the wall bracket into holes at the front end of phone. The bracket has two round plastic holes that can be used to hang your phone on the wallplate on your wall.

Note: If you do not wish to mount your phone on the wall, the Wall Mount Bracket can be reversed to raise the angle of the phone’s display when sitting on a table or desk.

4 W W W.T A L K S W I T C H . C O M