To install the car handsfree

The car handsfree should be installed by authorized personnel.

1 Disconnect the car battery.

2 Place the electronic box under the dashboard of the car. See also installation chart on page 2. It is recommended that the upper side of the electronic box faces the driver with no metallic barrier between the box and the driver.

Use the velcro enclosed in the kit to fasten the electronic box.

• Connect the hub to the electronic box, where labelled .

• Connect the bundle of power cables (red and black), music mute cable (yellow) and ignition sense cable (blue) to the electronic box, where

labelled .

3 Connect the black power cable to negative ground. Connect the red power cable, with the integrated fuse, to the positive pole on the car battery. Please note that supply voltages other than 12 volts may cause damage to the equipment.

4 Connect the yellow music mute cable to the car stereo. See A in installation chart on page 2.

5 Connect the blue ignition sense cable to the ignition of the car. See B in installation chart on page 2.

English

6Place the microphone on a fixed part of the car interior, preferably in the middle above the wind screen. Place it directed towards the driver and away from the loudspeaker(s). Place it away from air flows such as windows and ventilation. Make sure that the cable is long enough to reach the electronic box.

• Connect the microphone to the electronic box,

where labelled .

7Place the loudspeaker at least 50 cm (20 inches) from the microphone. Make sure that the cable is long enough to reach the electronic box.

•Connect the external loudspeaker to the electronic box, where labelled .

The display and control unit must be placed so that in case of a car accident, driver or passengers do not risk being hurt by hitting them.

8Choose a suitable location, for the control unit, for example near the emergency break. The driver must be able to reach the keys of the control unit from the normal driving position. Make sure that the cable is long enough to reach the electronic box. To be able to change the direction of how the cable leads away from the control unit, you have to take off the bottom cover, and then put it back again. Place the control unit in the location you have chosen.

•Connect the control unit cable to the hub, where labelled COM.

This is the Internet version of the user's guide. © Print only for private use.

15