7 – Reference and specifications
Troubleshooting
Symptom | Possible cause and remedy |
|
|
No power when POWER is pressed | The power cord is not inserted properly. Check and correct this. |
|
|
Hum on playback | Audio connections not made properly. Check the connections |
|
|
No audio output | The external amplifier is not properly connected, or the wrong set of inputs connected to |
| the active LINE OUTPUTs has been selected on the amplifier. Check and correct. |
|
|
The remote control does not seem to work | Is the power on? Are the batteries in the remote control dead? Is the remote control unit |
| too far away or at the wrong angle for correct operation (“Use of the remote control unit” on |
| page 10)? |
|
|
Low sound quality when playing back a tape | The heads are dirty or magnetized. See “Tape maintenance” on page 39. |
|
|
Sound is odd when playing back a tape | Pitch control may be off center (“Pitch control” on page 19) |
|
|
Tape recording cannot be carried out | The |
| recording level is set too low. |
|
|
Hum appears at the PHONO input | The grounding wire is not connected from the record deck to the |
|
|
No sound on playback (the disc is playing and | The connections from the |
the time display is incrementing) | erly, or the input source selector is not at the correct position. |
|
|
No meter indication when a source is input | Analog and/or digital volume (“Signal volume” on page 25) is set too low. The signal is |
| being input through an unselected input source (“Input selection” on page 25) |
| or |
| The input selection is not made correctly (“Recording operations” on page 17 (tape) or |
| “Input selection” on page 25 (disc). |
There is a gap in the
The A and B points are in different tracks.
The unit is in AUTO SPACE mode and is not playing (it is paused)
When the unit is automatically paused as a result of the auto space mode, pressing the AUTO SPACE key puts the unit into pause mode, and playback does not resume automat- ically after the auto pause time is elapsed (see “Auto spacing” on page 24).
A digital input source has been selected for CD recording, but the source is not connected | |
| or is not switched on. |
| |
Cannot record on a disc (pressing RECORD A finalized disc has been inserted. Use an unfinalized recordable disc. | |
shows MONITOR) |
|
|
|
PGM Full ! | An attempt has been made to create more than 25 program steps. |
|
|
Disc Full! | There is no space on the disc, or no tracks are available, or a general recording error has |
or Cannot Rec! | occurred. |
|
|
Disc Error | The disc is bad. If it is a |
| otherwise replace the disc. |
|
|
Erase Error! | An error has occurred while trying to erase the disc. |
|
|
The display suddenly shows PMA Writing | Either the disc is full (this message will be prefaced by Disc Full!! (“Full |
| disc” on page 27) or an attempt has been made to write more than 99 tracks. |
|
|
Rec Error | General recording error. This may be caused by vibration or a shock during recording, for |
| example, or may be the result of a bad disc. Try recording again with the same disc. If the |
| message appears again, try a different disc. |
|
|
System Err! | System error. |
|
|
Drive Error! | Error in the CD drive mechanism. |
|
|
36 TASCAM