Loading a CD
To load a CD, press the OPEN/CLOSE key on the main unit or on the remote control to open the disc tray, and put the CD into the tray with the label facing up.
Press the OPEN/CLOSE key again to close the disc tray. After loading the disc, the unit reads the disc’s information and shows on the display the total number of tracks and total playback time if it is an audio CD and the total number of tracks in the current folder if it is a data CD.
Instead of pressing the OPEN/CLOSE key to close the disc tray, you can press the PLAY/READY key to close the disc tray and begin playback immediately.
CAUTION
If you open the disc tray while this unit is in use, the following settings are lost.
•Program
•Current folder (for data CDs)
4 − Playing back CDs
Playback
The following procedures assume that the necessary connections have been completed, the unit’s power has been turned on and a CD (audio or data) has been loaded.
Press the PLAY/READY key on the main unit or remote control to begin playback of a CD.
PLAY/READY key
PLAY/READY key
ªª Stopping playback:
Press the STOP key on the main unit or the remote control.
ªª Pausing playback:
Press the PLAY/READY key on the main unit or the remote control.
In this manual, unless stated otherwise, explanations are given assuming that continuous playback mode is set. (See “Playback modes” on page 17.)
TASCAM