4 – Recording—Rehearsal
are sampled and looped. The position of the loop can be adjusted.
This section is looped. The MULTI DIAL control adjusts the position of the loop.
Drum beat
LVL | "1" | "2" | "3" | "4" | |
S | |||||
|
|
|
|
When this offset has been set, synchronized record- ing takes place with the start occurring at the new location:
Drum beat
LVL | "1" | "2" | "3" | "4" | |
S | |||||
|
|
|
|
Sync recording starts at new point
This example shows how the start time can be moved forward, in order to eliminate unwanted “false starts”. It is also possible to “slip” the start time back- wards, in order to record a quiet passage that would otherwise not trigger the sync recording facility (this is done by the use of a memory buffer).
As well as being used for changing the start time of synchronized recording, the start of an automatic track division can also be trimmed backwards and forwards in a similar way.
Both the sync start trim and the track start trim can take the same value and can be used in the same recording.
The maximum trim value is 125 frames on either side of the original point (represented by 0), where there are 75 frames in a second (i.e. 1.67 seconds).
4.5.1Rehearsal for synchronized recording
To perform a synchronized recording, using the rehearsal mode to slip the start of the track forwards or backwards:
1Load a recordable disc into the unit and make sure the unit is in stop mode.
2Cue the source material to the start of the source track to be recorded (i.e. in the example above, this would be just before the
3Press the RHSL key 4 so that the display shows Waiting Sync.
4Start playing the source. When the start of the track is detected (as explained in 4.3.1, “Syn- chronized recording”), the display changes to
Sync RHSL.
5If the rehearsal does not start at the region of the true start point, press the RHSL key once again to
6After nine seconds, the message changes from Sync RHSL, and the sampled data loops
in a
7Stop the source.
8Turn the MULTI DIAL control B to adjust the point of the loop. The display shows:
or
TRIM =
Every time the trim value is changed, the loop starts replaying from the new start point.
9When the new start point has been set, press the STOP key (G or I).
10Cue up the source material to the original point set in step 2.
11Press the RECORD key (J or D) to enter record ready mode, and then press the SYNC REC key (K or E).
12Start playing the source material. The unit starts recording, with the start point being determined by the trim value.
NOTE
If a trim setting is made for the sync start, this will apply to all sync starts and track divisions made in the future until the value is reset using the procedure above.
26 TASCAM
