Tascam owner manual Installation, Configure For Your Mixer, Installing the IF-FW/DM

Installation

Configure For Your Mixer

There is a series of jumpers on the IF-FW/ DM that set its operating mode. These jump- ers must be in the correct position to operate with a DM-3200 or DM-24, which com- municate with the IF-FW/DM via different operating modes.

Early IF-FW/DM cards shipped configured for the DM-24. From the time of DM-3200 software version 1.20 availability, IF-FW/ DM cards began shipping configured for the DM-3200.

Please confirm your card’s configuration with the following pictures and instructions then make any necessary changes before installing the IF-FW/DM into your mixer.

NOTE

•The IF-FW/DM will not function if incor- rectly configured for your mixer. Installing an incorrectly configured card will not harm anything.

•The IF-FW/DM must be installed in either mixer’s Slot 1. It will not function in Slot 2.

Use commonly available needle-nose pliers to carefully change the configuration of the card as shown.

Picture 1 is IF-FW/DM Configured for a DM-3200. Note that jumpers J11 through J43 are across pin rows 2 and 3.

J11 - J43

SDT : 1-2 (default)

LVDS : 2-3

U43 U42 U41 U40 U26 U25 U24 U23 U35 U34 U32 U31 U18 U17 U16 U15
			1
			2
			3
3
2
1
		U39 U38 U37 U36 U22 U21 U20 U19 U30 U29 U28 U27 U14 U13 U12 U11
	Card edge

Picture 1

Picture 2 is IF-FW/DM Configured for a DM-24. Note that jumpers J11 through J43 are across pin rows 1 and 2.

J11 - J43

SDT : 1-2 (default)

LVDS : 2-3

U43 U42 U41 U40 U26 U25 U24 U23 U35 U34 U32 U31 U18 U17 U16 U15
		1
		2
		3
3
2
1
	U39 U38 U37 U36 U22 U21 U20 U19 U30 U29 U28 U27 U14		U13 U12 U11

Card edge

Picture 2

Installing the IF-FW/DM

1.Remove the five screws holding the blank plate or card currently installed in Slot 1 then remove the plate or card.

2.Insert the IF-FW/DM into Slot 1, mak- ing sure that the card edges slide into the white plastic guide inside Slot 1. Push it all the way in until it clicks and the card back plate is flush with the mixer’s back panel. Excessive force is not required - if it does not click in easily, remove it and

start again with attention to the guides.

3.Replace the five screws to hold the card in place.

NOTE

•The IF-FW/DM must be installed in to the mixer’s Slot 1. It will not function in Slot 2.

•The following installation must be done with the mixer’s power OFF and disconnected.

 TASCAM IF-FW/DM Owner's Manual