Tascam System Clocking, IF-FW/DM & Mixer Routing, Master Clock, Clock Settings, Mixer Outputs

Setup

System Clocking

Master Clock

When configured with the IF-FW/DM, the mixer must be the master clock relative to the computer DAW. The mixer itself may be

clocked to an external source other than the DAW.

Clock Settings

If it becomes necessary to switch between 44.1k and 48k sample rates on the mixer, the following steps are required for correct operation:

1.Disconnect the FireWire cable between the DM-24 and the IF-FW/DM.

2.Change the sample rate on the DM-24.

3.Re-connect the FireWire cable.

NOTE

30seconds must elapse between disconnec- tion and reconnection of the FireWire cable.

96 k & 88.2 k Operation

The IF-FW/DM does not support these sam- ple rates.

IF-FW/DM & Mixer Routing

The IF-FW/DM appears to a mixer just like any other optional I/O card except that it has

24 channels of I/O instead of 8.

Mixer Outputs

DM-3200

By default, the DM-3200 duplicates busses 1 - 8 on IF-FW/DM mixer outputs 17 - 24.

Also available are the Direct Outputs from channels 1 - 16. By default, those appear on IF-FW/DM mixer outputs 1 - 16.

These routing settings can be changed in the OUTPUT tab of the DM-3200’s ROUTING screen.

 TASCAM IF-FW/DM Owner's Manual