English

2.4. Front Panel

vPGM 2 FADER REVERSE

Sets the direction of PGM 2 FADER operation. NORMAL: Moving the PGM fader up makes the

volume increase.

REVERSE: Moving the PGM fader up makes the volume decrease.

bPGM 2 FADER CURVE

Allows you to adjust the PGM 2 FADER response curve from soft (counter-clockwise) to hard (clockwise).

nCROSS FADER REVERSE

Sets the direction of CROSS FADER operation. NORMAL: Moving the CROSS FADER toward A

makes A signal louder and the other way round.

REVERSE: Moving the CROSS FADER toward A makes B signal louder and the other way round.

mCROSS FADER CURVE

Allows you to adjust the CROSS FADER response curve from soft (counter-clockwise) to hard (clockwise).

,PGM 1 FADER REVERSE

Sets the direction of PGM 1 FADER operation. NORMAL: Moving up the PGM fader makes the

volume increase.

REVERSE: Moving up the PGM fader makes the volume decrease.

.PGM 1 FADER CURVE

Allows you to adjust the PGM 1 FADER response curve from soft (counter-clockwise) to hard (clockwise).

/PHONES LEVEL

Adjusts the headphone output level.

!PHONES

Connect your headphone to this jack.

3. Modification

3. Modification

3.1. Output level

XS-8 has two MASTER outputs.

MASTER OUTPUT 1 (27): Balanced XLR connectors

MASTER OUTPUT 2 (28): Unbalanced RCA jacks These output level is set to 0 dBV. These output levels can be changed to +6dBV with jumpers. (See diagram below.)

WARNING

Changes on the Output Level have to be performed by a qualified technician.

NOTE

You must be careful when setting up the nominal output level of the mixer. The "clip" display of the connected power amplifiers must never remain permanently lightened up, but do it occasionally by following the rhythm of the bass signals that are being played.

JUMPER PIN

CONFIGURATION.

TOP VIEW

FACTORY ADJUSTED

OUT 1

0dB

0dB

OUT 2

0dB

 

 

 

+6dB

OUT 1 L

OUT 1 R

OUT 2 L

OUT 2 R

8 TASCAM XS-8