Section 3 | Safety |
|
|
We at Taylor Company are concerned about the safety of the operator when he or she comes in contact with the freezer and its parts. Taylor has gone to extreme efforts to design and manufacture
IMPORTANT
DO NOT operate the freezer without reading this Operator Manual. Failure to follow this instruction may result in equipment damage, poor freezer performance, health hazards, or personal injury.
Per IEC
This unit is provided with an equipotential grounding lug that is to be properly attached to the rear of the frame by the authorized installer. The installation location is marked by the equipotential bonding symbol (5021 of IEC
DO NOT use a water jet to clean or rinse the freezer. Failure to follow these instructions may result in serious electrical shock.
SDO NOT operate the freezer unless it is properly grounded.
SDO NOT operate the freezer with larger fuses than specified on the freezer data label.
SAll repairs must be performed by an authorized Taylor service technician. The main power supplies to the machine must be disconnected prior to performing any repairs.
SCord Connected Units: Only Taylor authorized service technicians may install a plug on this unit.
SStationary appliances which are not equipped with a power cord and a plug or another device to disconnect the appliance from the power source must have an
SAppliances that are permanently connected to fixed wiring and for which leakage currents may exceed 10 mA, particularly when disconnected, not used for long periods, or during initial installation, shall have protective devices such as a GFI to protect against the leakage of current, installed by authorized personnel to the local codes.
SSupply cords used with this unit shall be
Failure to follow these instructions may result in electrocution. Contact your local authorized Taylor Distributor for service.
|
| 110414 |
|
|
|
Model 430 Torque | 5 | Safety |