17
Model C043 Operating Procedures
111216
Door Assembly
Step 1
With the door in a horizontal position, install the
draw arm plate. Install all three short stud nuts and
leave them loose.
Figure 15
Step 2
Turn the door over and install the door gasket.
Note: DO NOT lubricate the gasket, as this will
cause the gasket to leak over time.
Step 3
Press all around the gasket to ensure a flush,
secure fit in the groove. The gasket may have t o be
stretched slightly to get it into the proper posit ion.
To ensure that the gasket is correctly posit ioned,
verify that the middle section of the gasket is arched
upward. If the middle section of the gasket is
concave, or extends into the middle of the seal, t urn
the gasket over, as it is upside down.
Figure 16
Step 4
Seat the door on the freezer studs. To ensure t he
door gasket doesn't fall off, hold the door flush wit h
the freezing cylinder with one hand while installing
the stud nuts with the other hand. Hand-tighten the
stud nuts equally in a criss-cross pattern to ins ure
the door is snug.
Figure 17
Step 5
Repeat the assembly instruction s on the
remaining freezingcylinders.