17
ModelsQS10 & QS22 OperatingProcedures
Section 6 Operating Procedures
The Model QS10 has one 12” (305 mm) lower cook
surface and one 11” (279 mm) upper platen.
The Model QS22 has two 12” (305 mm) lower cook
surfaces and two 11” (279 mm) upper platens.
The two-sided cooking concept ensures quick, even
cooking of both sides of products placed on the low-
er surface.
The Model QS22 has been selected to illustrate the
step-by-step operating procedures.
We begin our instructions with the opening proce-
dures, assuming product set-up procedures (out-
lined in the “Important to the Operator” section of
this manual) are complete.

Opening Procedures

Before operating the grill, the release material
sheets must be installed on the upper platen.
Perform the following steps for installing release ma-
terial sheets:
CAUTION: Make sure the grill is COOL
before attempting to install o r remove release
material sheets.
Step 1
Slide the release retainer through the hemmed end
of the release material sheet.
Figure 9
Step 2
Line up the two notches on the release retainer with
the release material shoulder screws located at the
top of the upper platen. Hang the release retainer on
the shoulder screws.
Figure 10
Step 3
Hold the non-hemmed end of the release material
sheet. Gently pull the sheet tight, wrapping it around
the platen in a side-to-side manner.
Figure 11
Note: Make sure the release material fits smoothly
and covers the upper platen from front to back. To
adjust the position, carefully move the sheet from
front to back.