18 ModelsQS10 & QS22Operating Procedures
Step 4
Place the release material clips over the release
material sheet, pressing them into place over the
release material bar at the top of the platen.
Figure 12
Step 5
Check the alignment and tightness of the release
material against the upper platen.
Step 6
Repeatsteps 1 through 5 for the remaining upper
platen(s) on the QS22.
Note: It is not necessary to change the release
material if small pin holes develop.
The release material must be changed when :
SProduct sticks to the release material.
SCarbon builds up, causing problems in taste
or appearance.
SThere is a tear in the release material in the
cooking area.
SThe release material substance is worn from
the release material sheet.
SThe temperature of the upper platen drops
more than 10_F. (5.6_C.) from the tempera-
ture recorded when the release material was
removed.
Note: Temperature checks should only be con-
ducted with the release material sheets removed.
Note: Rotate and reverse the release material
sheets on a daily basis.
Care of Release Material Sheets
SDO NOT fold or crease.
SDO NOT touch with any sharp object or
abrasive.
SDO NOT hose with hot water or soak in
water.
SDO NOT place under other objects.