22 ModelsQS10 & QS22Operating Procedures
Step 5
Carefullyremove the grease tray partition.Take it to
the sink for cleaning.
Figure 21
Note: For installation of the grease tray partition,
carefully reverse the above steps.
Closing Procedures
Step 1
Raise the upper cook surface to the raised position.
Step 2
Turn the power switches to the OFF position.
Figure 22
Step 3
Wipe the release material sheet thoroughly while still
attached to the upper cook surface, using the rubber
wiper squeegee.
CAUTION: The upper cook surface and
release material sheets are very hot. To prevent
burn injuries, wear protective g loves and use ex-
treme care when performing this procedu re.
Step 4
Holding a dry towel in both hands, remove the upper
release material clips by pulling up on the tab to
snapthe clips off the bar.
Step 5
Holding the dry towel in both hands, remove the
release material.
Step 6
Take the release material clips and the release
retainer to the sink for cleaning.
Step 7
Repeat steps 1 through 4 for the other upper platen
on the QS22.
Step 8
Clean the upper cook surface(s) with the special
rubber squeegee.
Note: DO NOT use metal scrapers, abrasive pads,
screens or wire brushes to clean the upper cook
surface.
CAUTION: Protect eyes, lungs, and all
partsof the body from potential harm when
using any chemical cleaner.
Step 9
To clean the upper cook surface, use a spray bottle
of full strength cleaner/degreaser (i.e., SizzlerGr ill
Bun and Toaster Cleaner, a Kay Chemicalr
product). Hold the bottle 6" (152 mm) away and mist
the entire upper cook surface, starting at the front.
(Usea cleaner that will not damage aluminum.)
Mist one ounce of cleaner over each upper cook
surface and two ounces on the lower cook surface.
Let the cleaner soak for 3-5 minutes. (Note: One
ounce of cleaner equals approximately thirty
squirts.)