4 Models QS10 & QS22Safety
Section 3 Safety
We at Taylor Company are deeply concerned about
the safety of the operator when he or she comes in
contact with the grill and its parts. Taylor has gone
to extreme efforts to design and manufacture built-in
safety features to protect both you and the service
technician. As an example, warning labels have
been attached to the grill to further point out safety
precautions to the operator.

To Operate Safely:

DO NOT operate the grill without reading
this operator's manual. This manual should be kept
in a safe place for future reference.
SDO NOT operate the grill unless it is
properly grounded.
SDO NOT use the cord if it is frayed.
SDO NOT attempt any repairs unless the
power supply to the grill has been
disconnected.
SDO NOT operate the grill unless all service
panels are restrained with screws.
SStationary appliances which are not
equipped with a power cord and a plug or
other device to disconnect the appliance
from the power source must have an all-pole
disconnecting device with a contact gap of
at least 3 mm installed in the external
installation.
Failure to follow these instructions may result in
electrocution. Contact your local Taylor Distributor
for authorized service.
Grill clearance must be maintained at least
3” (76 mm) from all combustible materials
(0” to non-combustible materials).
Failure to comply could result in a fire hazard.
All grills require 3” (76 mm) of air clearance in the
rear. Failure to comply will hinder grill performance.
DO NOT use a water jet to clean or rinse
the grill. Failure to follow this instruction may result
in the following:
S serious electrical shock
S burns from hot steam
S liquid collecting inside the grill and
destroying electrical components.
SDO NOT prepare or remove product without
proper equipment.
SDO NOT allow untrained personnel to
operate this grill.
SUSE EXTREME CAUTION when cleaning
the grill.
Failure to follow these instructions may result in
severe burns from high temperatures.
This grill must be placed on a level surface.
Failure to comply may result in personal injury or
equipment damage.
CAUTION: DO NOT attempt to use the
grill during a power outage. Grills require
electrical power for operation. In the event of a
prolonged power outage, place the unit in the “OFF”
position.
DO NOT slide the grill with the legs
attached. Failure to follow this instruction may
damage the grill.
NOISE LEVEL: Airborne noise emission does not
exceed 70 dB(A) when measured at a distance of
1.0 meter from the surface of the machine and at a
height of 1.6 meters from the floor.