TC electronic SDN BHD PowerCore user manual Powercore Hardware Installation Guide

Models: PowerCore

1 22
Download 22 pages 52.87 Kb
Page 9
Image 9

E N G L I S H

POWERCORE HARDWARE INSTALLATION GUIDE

HARDWARE INSTALLATION

POWERCORE PCI MKII, EXPRESS & UNPLUGGED

In the following pages, we will show you in detail how to install the PowerCore PCI mkII card in your computer. In this example we use a Windows based PC, but the installation procedure will also work with Macs. Please note that the procedure for opening and closing your computer case might differ. Make sure you consult the operating manual of your computer for further details.

1.Shut down your computer and make sure the power is OFF and the power lead to your computer is disconnected!

2.Open your computer. Discharge any static electricity from your clothes and body before you continue. This can be done by touching the internal frame of the computers case.

3.Remove the screw and the blind panel on the free PCI *) slot you are planning to use.

*) PowerCore Express must be installed in a PCIe slot. Check the specifications of your computer to see if it facilitates PCIe.

The PCI Express (PCIe) bus is a new incarnation of the PCI bus. Note that PowerCore Express is physically incompatible with a standard PCI port.

4.Insert the card carefully, and make sure that it is fitted properly into the slot.

5.Now tighten the screw in order to secure the card.

6.Close the case and then connect the power lead again.

PowerCore PCI mkII & Unplugged Special Jumper settings

PowerCore PCI mkII supports both 33MHz and 66MHz PCI bus speeds.

In its default position the PowerCore card will run at a PCI bus speed of either 33MHz or 66MHz, depending on your PCI bus speed. By moving the jumper to the“Force 33MHz” position, the card is

forced to run at 33 MHz. We highly recommend

MHz

J3

MHz

 

 

that you leave all jumper settings in their default

Force33

 

33/66

position, unless instructed by a TC Electronic

 

 

 

 

service technician to do otherwise. Other jumpers on the card should be left untouched, as they are used only for hardware testing purposes in a qualified TC Service Center.

The PCI-X bus architecture used in most Mac G5-models is backwards compatible with PCI. PowerCore PCI mkII is therefore compatible PCI-X based models.

E N G L I S H

14 / POWERCORE

POWERCORE / 15

Page 9
Image 9
TC electronic SDN BHD PowerCore user manual Powercore Hardware Installation Guide