DA-88 Digital Dubbing

DA-88 quick ref.doc
10/14/97	7:27 PM

Requirements:

1 PW-88S Sync Cable

1 PW-88D Digital Dubbing Cable

1 RCA to RCA audio cable. (If dubbing Time code)

2 DA-88s (Both must have SY-88 Sync cards if dubbing Time code) 1 Pre-Formatted tape.

Procedure:

1)With power off, connect Source DA-88 SYNC OUT to Target DA-88 SYNC IN using the PW-88 Sync cable.

2)With Power off, connect Source DA-88 DIGITAL I/O port to Target DIGITAL I/O port using the PW-88D Digital Dubbing cable.

If dubbing Time code, connect TC Out from source DA-88 to TC In on the target DA-88 using the RCA to RCA audio cable.

3)Power On both DA-88s

4)On the Source DA-88, enter a 43 Fs Track Delay value for all 8 tracks.

a)Press DISPLAY until ABS is selected.

b)Hold the and press DIGITAL IN. The display will toggle between Analog and Digital. Select DIGITAL.

c) If dubbing Time code, on Source DA-88 set menu Item 6 to Digital (old S1 #5 Up).

5)Load Master tape into Source DA-88 and the pre-formatted tape into the target DA-88.

NOTE: Make certain that the master tape is WRITE PROTECTED.

6)Make certain that the REC FUNCTION switches on the Source DA-88 are NOT ENGAGED.

7)Engage REC FUNCTION switches on the Target DA-88 to arm all tracks.

If dubbing Time code, engage the TC REC FUNCTION switch, but DO NOT start the generator.

8)Rewind both tapes to BOT

9)On the Target DA-88, engage DIGITAL IN, and CHASE.

10)On the Source DA-88, hold RECORD and press play.

Page 8

Teac manual DA-88 Digital Dubbing