Power Sources/Battery
This section provides information on the power sources available to the PortaDVD, including the battery and the AC adapter.
Power Sources
The PortaDVD drive does not have an On/Off switch. It is ready for operation when connected to the computer under one of these power sources:
❏AC adapter
❏Charged integrated battery pack
❏Portable computer using PCMCIA card
Power Settings
The power supply selection switch has two settings:
1.Set the power supply selection switch (see page 4) to “Batt./DC” to power the drive via the integrated battery pack or the AC adapter. If the AC adapter is connected, it will supply power to the drive. If the AC adapter is not connected and the battery pack is charged, the drive will be powered by the battery pack.
2.Set the power supply selection switch to “PC” to power the drive via the PCMCIA cable.
Charging the Battery Pack
The integrated battery pack can be charged automatically when the AC adapter is connected to the drive and plugged into an electrical outlet. The drive does not have to be connected to the computer to charge the battery pack. Allow up to five hours for the initial charge time to fully charge an empty battery pack. A fully charged battery will last up to two hours.
Removing the Battery Pack
When removing the battery pack, do not use a metal object. Doing so could short circuit the battery pack or damage the drive.
Only use TEAC integrated rechargeable battery packs. Standard commercial batteries could damage the drive.
Operating Orientation
Place the TEAC PortaDVD drive on a stable, level surface for operation. The surface should be within 10° of horizontal.
Caution: Do not operate the drive
TEAC PortaDVD User’s Manual | 3 |
