Technicolor - Thomson 42WM03STW-0707 important safety instructions Remote control, Blue Inactive

Remote control

Most of your plasma monitor functions are available via the menus that appear on the screen. The remote control supplied with your set can be used to navigate through the menus and to configure all the general settings.

EN

6

(red) To access the sleep timer.

Inactive

To enable the PIP function.

Inactive

To swap the main picture with the PIP picture.

To change position of the PIP on screen.

To change channels within the PIP function.

To control the volume.

To switch the sound off and back on again.

To close menus.

(av): To select an appliance connected to an AV socket (Scart or cinch sockets).

(green) (yellow) To access status

Inactive information.

Standby.

(blue) Inactive

(purple) To access Teletext.

(up and down buttons): To select the options in menus.

(left and right buttons): To adjust settings, change values, switch certain functions on and off, and use the zoom function.

To confirm a selection.

To access the OVER-

VIEW menu.

To change channels.

(numeric buttons): To select a channel by entering its number, or to enter numeric values in menus.

Note:

The coloured buttons are also used for operating Teletext.

IMPORTANT

If the batteries in your remote control are run down, you can use the buttons on the front of the set, as they have the same functions as those of the remote control.

42WM03STW-0707-en.p65 6 2003/9/5, PM 12:52