Getting Started
Unpacking The Speakers
•one set of speakers including 2 front speakers, 1 centre speaker, 1 subwoofer and 2 rear speakers.
•6 speaker wires including:
Set up and Maintenance of the Receiver
EN
•Provide spaces for sufficient ventilation as indicated:
10 cm/4"
| H O M E | T H E A T E R A U D I O | V I D E O R E C E I V E R |
| VOLUME |
|
| |
10 cm/ | ON/STANDBY |
|
|
|
|
|
| 10 cm/ |
4" |
| SOURCE |
|
|
| SURR MODE |
| 4" |
MUTE | FM/AM | TUNING | MEMORY | SETUP TEST TONE EQ DIGITAL INPUT | BASS/TREBLE | LEVEL | ||
|
| SOURCE |
|
|
| DSP MODE |
|
|
ST / MONO
1 X green/black wire for center speaker
1 X white/black wire for front left speaker
1 X blue/black wire for rear left speaker
1 X red/black wire for front right speaker
1 X purple/black wire for subwoofer
1 X gray/black wire for rear right speaker
PHONES | VIDEO | L - AUDIO - R | |
| 10 cm/4" |
|
|
5 cm/ |
|
|
|
2" |
|
|
|
• Do not connect to the AC power cords until all |
connections are completed. |
• Do not use your set immediately after transferring |
it from a cold place to a warm place: there is risk of |
condensation. |
• Do not expose your set to water and excessively |
Inserting Batteries into Remote Control
Insert two AA(R6) batteries according to the + and - signs on the battery compartment. To use the remote control, point it directly at your receiver. Whenever a button is pressed, a red indicator will light up on the remote control.
Install batteries as follows:
1.Remove battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet.
2.Insert 2 AA batteries in the compartment and replace the compartment door.
high temperatures. |
• After having disconnected your set, clean the case |
with a soft cloth, or with a slightly damp leather |
chamois. Never use strong solvents. |
Protect your Components from
Overheating
•Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.
•Do not stack components directly on top of each other.
•Allow adequate ventilation when placing your components in a stand.
•Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other com- ponents. If you have a satellite receiver, you should place it on the top shelf.
3
