Technics SA-GX 19O manual Preset tuning, e errJ, Before presetting, Automatic memory presetting

Preset tuning

By presetting the desired broadcast stations into the memory channels of this unit, broadcast stations can be selected simply by pressing numeric button(s). (Refer to page 15 for tuning.)

-Beforepresetting

How many broadcast stations can be preset?

A total of 30 FM and AM stations can be preset.

How is presetting done?

The two following methods are available.

• Automatic memory presetting

Automatic memory presetting allows this unit to automatical- ly search for broadcast stations and then preset them into

memory.

With this function, searching proceeds from the frequency currently being displayed and continues through higher fre- quencies, (up to 107.9 MHz for FM, up to 1710 kHz for AM) and broadcast stations are preset in the order in which they are located.

With this method, the channel ranges that can be preset into the memory for different bands (FM or AM) are set as follows.

			Channel
_			FM	_l
For	FM	broadcast	stations	1-30
For	AM	broadcast	stations	21 -30

If the FM stations (channels 1-30) are preset and then the AM stations (channels 21 -30) are preset:

Because this unit can accommodate a total of 30 preset channels, the settings for FM channels 21-30 will be replac- ed by the AM settings which were subsequently preset, and the channel allotment will be as shown below.

Channel

For	FM	broadcast	stations	1-20
For	AM	broadcast	stations	21-30
• Manual		memory	presetting

The desired broadcast stations can be preset into the desired channels by the user.

This can also be used as a method for changing selected broadcast stations that were preset in "Automatic memory presetting".

Please remember this:

If a new broadcast station is preset into a channel, the set- ting for the broadcast station which was previously entered in that channel will be automatically erased.

Automatic memory presetting

J

Press TUNER.

....... e'_'N'D..... Press BAN Dto seiect ,_FM ;,

L

3_	'settothewant	frequency	from which you
		start automatic	memory preset-

ting. (Follow steps 3 and 4 on page 12.)

..... "E_:;R_.... Press MEMoRYontiithe ire.

[ _ j quency begins to change.

'_'k_-"(Automatic memory presetting will

start.)

To stop press MEMORY once again.

When a broadcast station is preset

The memory indicator and the preset channel number will be displayed for approximately 1 second.

	MEMORY
	I	i	L_/	/
r-_		I-	III	I

Illumi!ates

When presetting is completed

The last broadcast station to be preset will be displayed.

e errJ

Correct presetting may not be possible in cases where.the broad- cast waves are too strong or too weak. In such cases, carry out presetting manually.

14