,ilililililiiiii,i,iiiiiiiiiiiilii,

Battery installation

Insert the batteries included with this unit as shown below.

Check the (+)

1-)sides.

When you need to replace these batteries

Use two UM-4 "AAA", IEC R03 (1.5 V) or equivalent batteries.

Use of batteries

Do not mix old and new batteries, or batteries of different types (carbon and alkaline, etc.).

Always remove old, weak or worn-outbatteries promptly and dispose of them properly.

The battery life is about one year.

Although the battery life varies depending on how often the device is used, the batteries should be replaced about once every year on the average.

The batteries should be replaced if commands from the remote control transmitter do not operate the unit even when transmitter is held close to the front panel.

Never subject batteries to excessive heat or flame; do not at-

tempt to disassemble them; and be sure they are not short-cir- cuited.

If the remote control is not to be used for a long period of time, remove the batteries and store them in a cool, dark place.

If a battery leaks, remove all batteries and dispose of them pro- perly. Thoroughly clean the battery compartment before inser- ting new batteries.

If the electrolyte comes into contact with skin or clothes, flush with water immediately.

Keep batteries out of reach of children.

Do not use rechargeable (nickel-cadmium) type batteries.

Do not attempt to recharge alkaline or carbon batteries.

Method for use

Use the remote control within 60 degrees and within 7 meters (23 ft.) facing directly toward the receiver's remote control signal receptor.

J

.................,., [_ T ......'..

About 7 meters in front of the

sensor

(The actual range will depend on the angle at which the remote control is used.)

Operation notes

Aim the remote control's transmission window toward the unit's sensor. Avoid any obstacles.

l ==lsoOl

_°oo°o

o

_t/t

t t t i°1_

Avoid dust

Avoid dust

Be sure the transmission window and the unit's sensor are free from dust. Excessive dust might affect performance.

The operation may not be correct if direct sunlight or another strong light source strikes the receiving sensor of this unit. If

there is a problem, place the unit away from the light source.

When operating a TV, VCR, digital compact cassette deck (DCC) or a CD changer (or CD player) with a remote control sensor, face this remote control toward the remote control sensor of the unit to be operated.

]7

Page 17
Image 17
Technics SA-GX 19O manual Use of batteries, Method for use, Operation notes, Sides