Technics SL-PD947 Basic Operating Procedure, Label, on the disc, Load the discs, trays, Disc Skip

Basic Operating Procedure

on the disc	l
3 Load the disc(s)	1
tray(s).	J	DISC SKIP

1 Press POWER to switch on the power.

2 Press OPENICLOSE to open the loading

drawer.

(Also available from the remote control.)

3 Load the disc(s) on the disc tray(s).

Do not load 3" (8 cm) and 5" (12 cm) discs on the same disc tray.

PLAY

4 Press OPENICLOSE again to close the loading drawer.

(Also available from the remote control.)

You can skip this step by pressing PLAY.

The loading drawer will be closed automatically then play will

start.

Do not attempt to close the drawer by hand. Be sure to press

OPEN/CLOSE.

The number (1-5) on the disc tray indicates the disc number.

Label

must face
upward.	I	Carousel

After loading discs on the two disc trays at the front position, press DISC SKIP to move the carousel. A different two disc trays will be at the front position each time DISC SKIP is press- ed.

Notes:

Do not touch the carousel nor the loading drawer while it is

moving.

Do not turn the carousel forcibly by hand because it may fail to operate normally.

5 Press PLAY.

(Also available from the remote control.)

CAUTION:

Do not move this changer with a compact disc inside the unit. If a disc comes off the disc tray, it might be scratched or the changer might become incapable of playing. Refer to page 35 before moving the unit.

9