Concerning the Remote Control
Battery installation
fl | Openthe ] | f/'_ Insertthe I | ft'_ Cl°sethe] |
Open the cover, | Be sure that you insert the batteries so that their positive (+) | ||||
and negative | polarities | match the polarities indicated in | |||
Press gently and slide the cover out. | the compartment. | Batteries | installed with incorrect polarities | ||
|
| may leak and damage. |
| ||
2 Insert the | batteries Included with this unit. | Refer to "Use | of batteries" | for additional information. | |
IEC R03 (1.5 | V) or equivalent batteries. | 3 c,o,ethe | cover. |
| |
When you need to replace these batteries, use two |
|
|
|
|
Use of batteries
Do not try to mix old and new batteries or batteries of different types (carbon and alkaline, etc.).
Always remove old, weak or
The average battery life is about one year. Although the battery life varies depending on how often the device is used, you should generally replace the batteries about once a year.
Replace the batteries if commands from the remote control transmitter do not operate the unit even when the transmitter is held close to the front panel.
Never subject batteries to excessive heat or flame; do not attempt to disassemble them; and be sure they are not
If you will not use the remote control for a long period of time, remove the batteries and store them in a cool, dark place.
If a battery leaks, remove all batteries and dispose of them proper- ly. Thoroughly clean the battery compartment before inserting new batteries. If the leaking electrolyte comes into contact with skin or clothes, flush with water immediately.
Keep batteries out of reach of children.
Do not use rechargeable type
Do not attempt to recharge alkaline or carbon batteries.
Operation notes
B
(_) Aim the remote control transmission window toward the changer's sensor. Avoid any obstacles.
(_) Use the remote control within a
changer.
The reachable distance is within 7 meters (23 ft.) directly facing
toward the changer.
_Avoidd
(_) Be sure the transmission window and the changer's sensor are free from dust. Excessive dust might prevent reception.
If direct sunlight or other strong light sources strike the remote con- trol signal sensor of the changer, operation may be impaired. If there is a problem, place the changer away from the light source.
5