Technika LCD32-209V manual Connecting Other Equipment via Scart, Switching the TV On/Off

Connecting Other Equipment via

Scart

Most devices support SCART connection. You can connect a; DVD recorder, a VCR or a decoder to your LCD TV by using the SCART socket. Note that cables shown in the illustration are not supplied.

Power off both the TV and the devices before making any connections.

For more information, refer to your device’s own instruction book.

Scart socket

DVD Recorder Video Recorder Decoder

Inserting Batteries in the Remote

Control Handset

•Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Place the batteries in the right directions and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Remote range is approximately 7m/23ft.

Switching the TV On/Off

To Switch the TV On

•Connect the power cord to the 220-240V AC 50 Hz.

•Press STANDBY switch. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, P+ / P- or a numeric button on the remote control.

•Press the -P/CHor P/CH+ button on the TV. The TV will then switch on.

Note: If you switch on your TV via PROGRAMME UP/DOWN buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV Off

•Press the “” button on the remote control or press the STANDBY switch, so the TV will switch to standby mode.

•To power down the TV completely, unplug the power cord from the mains socket.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

Input Selection

Once you have connected external systems to your TV, you can switch to different input sources.

•Press AV/SOURCE button on your remote control for directly changing sources.

or,

•Select “Source” option from the main menu by using “” or “” button. Use then “” or “” button to highlight an input and press “” button to select.

Note: You can mark desired source options by pressing the OK button. Therefore, when AV/ SOURCE button is pressed, only the marked source options will be available (except for the TV source).

English - 9 -

MB25_[GB]_(01-TV)_COST_1055UK_IDTV_32855W_BRONZE12_10063137 _50153024.indd 9 16.08.2009 11:42:24